Whetman Equipment
  • Home
  • Products
  • About
  • Contact
  • Lettmann
    • Whitewater Paddles
    • Sea Kayak Paddles
    • Lettmann Machete
    • Lettmann Manta Race Creeker
    • Lettmann Rocky Creeker
    • Lettmann Granate Creeker
    • Bullet River Play Kayak
    • Sea Kayaks: Biskaya
    • Sea Kayaks: Skinner
    • Sea Kayaks: Eski 475
    • Demo Sea Kayaks
  • Roof Racks
  • Store
  • Downloads
  • Videos
  • Stockists
  • Kayakphibians
  • Privacy Policy
  • News
  • Dog Lead
  • Gear Lab
D Ring Reinforced PVC Patch
Sea Kayak Pump Stow Kit
Sea Kayak Pump


D Ring Reinforced PVC Patch
25mm Stainless D Ring on a patch of heavy duty polyester mesh reinforced PVC. 
​Made in the UK.


Picture
Glue the patch on to your boat to create an anchor point to tie down kit such as air bags in a canoe, essential kit in hatches of sea kayaks, create a tie down point on a SUP or inflatable kayak, rig out your van.
12cm diameter reinforced pvc patch with 25mm x 4mm stainless D ring bar tacked with high tensile polyester thread.
Picture
Picture
Position the patch so the pull on the anchor aligns with the webbing and at a low angle for max strength.

Before glueing prepare both surfaces with sand paper & clean with alcohol wipes to remove any grease. Follow the glue instructions. 

What Glue?
To glue onto plastic boats and composite boats use a 2 part epoxy resin glue.
To glue onto PVC such as an inflatable kayak or SUP use a 2 part PVC glue: recommended supplier contact Ribstore in Plymouth email info@ribstore.co.uk  
​

STORE
The PVC reinforced patch will hold a considerable weight at a low angle shear as shown in the image opposite. 50kg of weight can be held without any signs of failure of the patch. The patch is not as strong if pulled at right angles to the surface it is attached to.
Picture

Sea Kayak Pump Stow Kit
Picture
Picture
Four 10cm diameter reinforced PVC patches with 100% brass eyelets link together with 6mm shockcord (pump not included in kit). Glue the patches to the boat approx 15cm apart & tie off the shock cord to an appropriate tension to hold the pump.

Important:

Check before hand that the fitting will not affect your ability to exit the boat!!! Different boats and leg sizes and pump sizes will have different issues on this aspect; once fitted test your exit before going on the water.

Picture
Picture

Sea Kayak Pump
Picture
The Kajaksport Sea Kayak Hand Pump is made in Finland. Kajaksport is a specialist manufacturer of sea kayak hardwear kit and focus on precision rudder and skeg systems. They have applied their engineering expertise to make a smooth operating robust pump which has a stainless steel piston rod. There are cheaper pumps on the market but the professionals choose this one. 
STORE
The pump is fitted with a shockcord lanyard & floating foam sleeve. The total length from base to top of the handle is 49cm.
Picture
Picture
Picture
Picture
Picture
Proudly powered by Weebly